Reasons for deformation of hydraulic filter housing

Hydraulic filter is the most common filter device in industrial production. Then many manufacturers often find the deformation of the filter housing during the use of hydraulic filters. Today, the author shares with you the causes of the deformation of the hydraulic filter housing.

First, the model selection is wrong. When choosing to use filters, many businesses chose some hydraulic filters with inferior quality to save costs, which caused the shell deformation.

Secondly, the impact of internal pressure is too large. In many cases, the internal pressure of the hydraulic filter cannot be completely controlled. Under the long-term impact of a certain pressure, it is easy to cause the shell deformation or even rupture.

Finally, the filter element problem. The filter element is a component that needs to be cleaned frequently. If it is not replaced for a long time, it will cause blockage. At this time, if the whole hydraulic filter is started at low temperature, it is easy to cause the internal pressure bearing value to exceed the maximum pressure bearing value of the original hydraulic filter, resulting in deformation of the appearance, and even damage to the filter.