What are the reasons why the oil filter cannot meet the standards for filtration? Shenzhen Wonpro Technology

As a manufacturer that has been producing and selling filtration equipment for nearly 20 years, we have accumulated many problems that often occur during the use of oil filters. Most of them are damaged due to improper use or failure to replace oil filter accessories in a timely manner, and many of them fail to meet the oil filtration standards. There are multiple reasons for not meeting the standards, how to solve them? Please provide a detailed introduction

Reasons for not meeting standards:

1. Poor filtration of impurities. If the filter element or filter paper is replaced, it means that the replacement of the filter element and filter paper does not meet the standard. Or the interface is not good, and there is oil leakage. Replace the filter element to check the filtration accuracy, and pay attention to the interface. Each manufacturer's interface will have some differences, so it is necessary to find a manufacturer to replace consumables. Avoid unnecessary trouble.

Secondly, it depends on what substances do not meet the standards in the oil, and each oil filter targets different impurities. For example, a centrifugal oil filter can remove water and impurities, but its zero crossing accuracy is not as good as a vacuum oil filter. The vacuum oil filter has high filtration accuracy, but its speed is slow and does not target a lot of moisture. The use of physical properties in oil filters cannot separate the mixture of oil and oil.

After filtering a type of oil, it is necessary to clean the inside of the equipment thoroughly to avoid oil contamination and mixing.

Normally, an oil filter produced by a legitimate manufacturer will not encounter these situations, and the consumables in the later stage can also be well guaranteed. Avoid small manufacturers not being able to provide good after-sales service.